A peer-reviewed journal published by K. N. Toosi University of Technology

Document Type : Research Article

Authors

1 Department of Physics, Najafabad Branch, Islamic Azad University, Najafabad, Iran.

2 Department of Energy Engineering and Physics, Amirkabir University of Technology, Tehran, Iran.

Abstract

For configuring plasma focus device (PFD), the gap between electrodes is filled out with a gas at low pressure. When discharge is starting at the surface of the insulator, the gas breaks down, leading to the flow of the plasma current sheath toward the anode end. A homogeneous and symmetric current sheath which is essential for ion emission and a proper plasma pinching can be obtained when there is an electrical breakdown along the insulator. Therefore, one of the most important parts of the plasma focus is the insulator. In the present research, the effect of different insulator sleeves on the intensity of ions emitted from a 4 kJ PFD filled with Neon has been studied. Pyrex and Quartz are considered for the insulator materials and the length is varied from 3 to 6 cm for Pyrex and from 3.5 to 5.5 for Quartz. Numerous gas pressures were experimented with voltages of 11, 12 and 13 kV. The results show that both the length and the material of the insulator sleeve can affect the intensity of ions emitted from the device. The length of 4.5 cm seems optimal to yield maximum ion emission for Pyrex insulator. For the Quartz insulator, on the other hand, length of 3.5 cm results in higher ion emission. In addition, in some cases, utilizing Quartz insulator causes more ion emission compared to the Pyrex insulator.

Highlights

• Ion emission in the Amirkabir plasma focus device.
• Effect of insulator length and material.
• Optimization of the performance of PFD.

Keywords

Agarwala, P., Annapoorni, S., Srivastava, M., et al. (1997). Magnetite phase due to energetic argon ion irradiation from a dense plasma focus on hematite thin film. Physics Letters A, 231(5-6):434–438.
Bhuyan, H., Mohanty, S., Borthakur, T., et al. (2001a). Analysis of nitrogen ion beam produced in dense plasma focus device using Faraday Cup.
Bhuyan, H., Mohanty, S., Borthakur, T., et al. (2001b). Analysis of nitrogen ion beam produced in dense plasma focus device using Faraday Cup.
Etaati, G., Amrollahi, R., Habibi, M., et al. (2011). Angular distribution of argon ions and X-ray emissions in the APF plasma focus device. Journal of Fusion Energy, 30(2):121–125.
Feugeas, J., Llonch, E., De Gonz´alez, C., et al. (1988a). Nitrogen implantation of AISI 304 stainless steel with a coaxial plasma gun. Journal of applied physics, 64(5):2648–2651.
Feugeas, J., Llonch, E., De Gonz´alez, C., et al. (1988b). Nitrogen implantation of AISI 304 stainless steel with a coaxial plasma gun. Journal of Applied Physics, 64(5):2648–2651.
Feugeas, J., Sanchez, G., De Gonzalez, C., et al. (1994). Pulsed ion implantation of nitrogen in pure titanium. Radiation Effects and Defects in Solids, 128(4):267–275.
Gribkov, V., Pimenov, V., Ivanov, L., et al. (2003). Interaction of high temperature deuterium plasma streams and fast ion beams with stainless steels in dense plasma focus device. Journal of Physics D: Applied Physics, 36(15):1817.
Habibi, M. (2012). Study of the electrode material and insulator length effect on high-energy x rays emitted by a 4-kJ plasma focus device. Plasma physics reports, 38(7):566–573.
Habibi, M. and Amrollahi, R. (2010). Anisotropic investigation of hard X-ray emission with flat anode tips in APF plasma focus device. Journal of fusion energy, 29(2):119–123.
Habibi, M., Amrollahi, R., and Attaran, M. (2009). Experimental study of current discharge behavior and hard X-ray anisotropy by APF plasma focus device. Journal of Fusion Energy, 28(1):130–134.
Kelly, H., Lepone, A., and Marquez, A. (1997). Nitrogen ion spectrum from a low energy plasma focus device. IEEE Transactions on Plasma Science, 25(3):455–459.
Kelly, H., Lepone, A., Marquez, A., et al. (1996). Coating on metallic samples produced by a small energy plasma focus. Plasma Sources Science and Technology, 5(4):704.
Koohestani, S., Habibi, M., and Amrollahi, R. (2013). Study of the effect of pyrex and quartz insulators on X-ray intensity in a 4 kJ plasma focus device. The European Physical Journal
D, 67(6):1–6.
Koohestani, S., Habibi, M., Amrollahi, R., et al. (2011). Effect of quartz and pyrex insulators length on hard-X ray signals in APF plasma focus device. Journal of fusion energy, 30(1):68–71.
Lee, S., Tou, T., Moo, S., et al. (1988). A simple facility for the teaching of plasma dynamics and plasma nuclear fusion. American Journal of Physics, 56(1):62–68.
Mather, J. W. and Bottoms, P. J. (1968). Characteristics of the dense plasma focus discharge. The physics of fluids, 11(3):611–618.
Mohanty, S. R., Bhuyan, H., Neog, N. K., et al. (2005). Development of multi faraday cup assembly for ion beam measurements from a low energy plasma focus device. Japanese Journal of Applied Physics, 44(7R):5199.
Mozer, A., Sadowski, M., Herold, H., et al. (1982). Experimental studies of fast deuterons, impurity-and admixture-ions emitted from a plasma focus. Journal of Applied Physics, 53(4):2959–2964.
Nayak, B., Acharya, B., Mohanty, S., et al. (2001). Surface nitriding of graphite substrate by plasma focus device towards synthesis of carbon nitride coating. Surface and Coatings Technology, 145(1-3):8–15.
Rawat, R., Arun, P., Vedeshwar, A., et al. (2000). Effect of argon ion irradiation on Sb2Te3 films in a dense plasma focus device. Materials research bulletin, 35(3):477–486.
Rawat, R., Lee, P., White, T., et al. (2001). Room temperature deposition of titanium carbide thin films using dense plasma focus device. Surface and Coatings Technology, 138(2-3):159-165.
Rawat, R., Zhang, T., Phua, C., et al. (2004). Effect of insulator sleeve length on soft x-ray emission from a neon-filled plasma focus device. Plasma Sources Science and Technology, 13(4):569.
Rawat, R. S., Srivastava, M., Tandon, S., et al. (1993). Crystallization of an amorphous lead zirconate titanate thin film with a dense-plasma-focus device. Physical Review B, 47(9):4858.
Rhee, M. (1984). Compact Thomson spectrometer. Review of Scientific Instruments, 55(8):1229–1234.
Rosenman, G., Shur, D., Krasik, Y. E., et al. (2000). Electron emission from ferroelectrics. Journal of applied physics, 88(11):6109–6161.
Sadowski, M., Rydygier, E., Herold, H., et al. (1985). Multispike structure of ion pulses generated by plasma focus discharges. Physics Letters A, 113(1):25–31.
Sadowski, M., Skladnik-Sadowska, E., Baranowski, J., et al. (2000). Comparison of characteristics of pulsed ion beams emitted from different small PF devices. Nukleonika, 45(3):179–184.
Sagar, R. and Srivastava, M. (1993). Amorphization of thin film of cds due to ion irradiation by dense plasma focus. Physics Letters A, 183(2-3):209–213.
Shyam, A. and Rout, R. (1997). Effect of anode and insulator materials on Plasma Focus sheath (pinch) current. IEEE transactions on plasma science, 25(5):1166–1168.
Srivastava, M., Mohanty, S., Annapoorni, S., et al. (1996). Diode like behaviour of an ion irradiated polyaniline film. Physics Letters A, 215(1-2):63–68.
Zakaullah, M., Ahmed, I., Rashid, N., et al. (1993). Influence of insulator contamination by copper evaporation on neutron yield in a low-energy plasma focus. Plasma physics and controlled fusion, 35(6):689.
Zakaullah, M., Baig, T., Beg, S., et al. (1989). Effect of insulator sleeve length on neutron emission in a plasma focus. Physics Letters A, 137(1-2):39–43.
Zhang, T., Lin, X., Chandra, K., et al. (2005). Current sheath curvature correlation with the neon soft x-ray emission from plasma focus device. Plasma Sources Science and Technology, 14(2):368.